Model: NL-XJPD-2
The problem
Carrying a floor washer up steps or dropping it onto the floor puts the whole impact on the handle and brush joint. That fishing-rod style beating is what kills clips and pins, yet nobody wants to swing a machine thousands of times by hand, and hand testing cannot reproduce force, angle or frequency, so 300 beats and 3000 beats are not comparable.
Capability
The bench clamps the handle at both ends in a chuck fixture and a servo drive beats the unit at a set angle and rate, simulating lifting, hanging and knocking against the floor. Beat angle 0-80deg, speed 1-40rpm freely settable, 0-999999 counts with automatic stop at target, PLC control with 7-inch touch screen, pine board table to damp secondary impact, aluminium profile frame with powder-coated panels. Single independent station as standard, expandable to two stations; about 700x1500x1350mm, AC220V 1.5kW. Gentle adjustable motion avoids artificial damage to the sample.
Key specifications
- Application: handle and brush joint strength and fishing-beat endurance of floor washers and vacuums
- Stations: 1 independent station as standard, expandable to 2
- Beat angle: 0-80deg adjustable
- Speed: 1-40rpm freely settable
- Counter: 0-999999, automatic stop at target
- Drive: servo motor with reduction unit
- Fixture: chuck type clamping both handle ends, jaws changeable by handle section
- Control: PLC with 7-inch touch screen
- Build: pine board table, aluminium profile frame with powder-coated panels
- Size and supply: about 700x1500x1350mm; AC220V 1.5kW
Applications
Handle moulding and clip strength validation; brush joint, pin and latch supplier comparison; reproduction of drop and knock complaints; new structure validation and competitor benchmarking
About the manufacturer
Guangdong Endurance Electronic Equipment Co., Ltd provides non-standard customization, drawing confirmation, factory acceptance, on-site installation and commissioning, operation training and lifetime technical service; 12-month warranty and lifetime spare parts supply. Tel: 0760-88500902 / 13416787649. Web: en.zsnaili.com.