Model: NL-JSFV-20
The problem
The inlet valve is where washer leak complaints start: weak start at low pressure, weeping seals at high pressure, deformation after hot-cold duty. Manual on-off benches cannot combine water pressure, temperature and coil voltage the way real duty does, so the failure never shows before shipment.
Capability
Twenty stations test drum and pulsator washer inlet valves in parallel, accepting BSPT/NPSM inlets and one-in-one-out or one-in-many-out outlets. Water pressure 0.02-1.2MPa with seven set points (0.02 / 0.05 / 0.1 / 0.2 / 0.5 / 0.8 / 1.0MPa); at stable pressure the system records the 30s average flow automatically. Water temperature 5-70degC by PID-controlled 304-stainless tank (about 200L) with automatic top-up and drain, level alarms, and easy cleaning. Coil supply AC 0-300V with 50/60Hz selection, plus AC/DC interfaces (DC24V, AC110V/AC220V) for both product families. Counting to 999999 cycles (300000 typical) within +/-2 counts, on/off times 1-999999s settable per station, any selection of stations running together. Station-to-display correspondence, independent ON/OFF and terminals per station, fault located on screen with tower light (green run / yellow standby / red fault). Configurable software logs pressure, flow, counts and frequency with compensation and flow calibration, exporting to Excel/Word; painted frame on casters.
Key specifications
- Application: durability testing of drum/pulsator washer water inlet valves
- Stations: 20, station-to-display correspondence, independent ON/OFF
- Pressure: 0.02-1.2MPa adjustable, 7 set steps; 30s average flow logged at stable pressure
- Water temperature: 5-70degC, PID controlled
- Coil supply: AC 0-300V, 50/60Hz; AC/DC interfaces DC24V / AC110V / AC220V
- Counting: 1-999999 settable, error <=2 counts
- On/off time: 1-999999s settable, independent per station
- Tank: 304 stainless 500x500x800mm approx. 200L, auto top-up/drain
- Alarm: tower light run/standby/fault, station-level on-screen indication
- Data: configurable software, Excel/Word export, parameter compensation and flow calibration
- Frame: painted, on casters, per-station grounded terminals
Applications
Life validation at inlet-valve and solenoid plants; incoming reliability audit by washer OEMs; durability sampling for export models; third-party component testing
About the manufacturer
Guangdong Endurance Electronic Equipment Co., Ltd provides non-standard customization, drawing confirmation, factory acceptance, on-site installation and commissioning, operation training and lifetime technical service; 12-month warranty and lifetime spare parts supply. Tel: 0760-88500902 / 13416787649. Web: en.zsnaili.com.