The problem
Static sealing tests cannot screen out field internal/external leakage; AS/NZS and EN endurance conditions need half the cycles at high temperature and each half over 24 hours - impossible by hand. This machine runs the full cycle automatically with torque-decay curves.
Capability
Media: water or air, output pressure adjustable; test pressure 0.05-0.8MPa, resolution 0.01bar; flow 4-400L/min via stainless multi-stage pump; torque sensor 4-200Nm records open/close torque decay; temperature ambient-70C (AS/NZS 60C hot segment); step motor drives reciprocating valve rotation, angle and speed settable (5 cycles/min); dwell at full open/close 0-5s settable; cycle count 1-10000 with auto stop; AS/NZS condition (half cycles at 60C or max use temperature, half at ambient/low temperature, each half at least 24h, pentane/toluene saturated air optional) and EN condition (-5C/-20C 9h pre-conditioning then sealing and torque test); PC + PLC control with touch screen; DN100-250 ball valve fixtures; built-in water tank with temperature controller.
Key specifications
- 适用对象：球阀、燃气比例阀等旋转类阀门的耐久寿命测试；适配DN100-250球阀专用夹具
- 试验介质：水/气双介质可选；气压输出压力可调
- 试验压力：0.05～0.8MPa（压力可选），压力值分辨率0.01bar
- 介质流量：4～400L/min（不锈钢多级泵输出，触摸屏/软件调节）
- 扭矩采集：扭矩传感器在线采集开关阀扭矩，范围4～200Nm，扭矩衰减全程记录
- 温度控制：温控器控制水箱介质温度，常温～70℃可设（澳标60℃高温段工况）
- 动作控制：步进电机驱动阀门往复旋转，角度/速度可调；测试速度5次/min（可设）
- 驻留时间：全开/全关位置停留0～5秒可设定，满足不同标准要求
- 循环次数：1～10000次设定，到次自动停机；测试次数自动记录
- 澳标工况：一半次数60℃（或厂商最大使用温度）+一半次数常温/低温；任一半次数≥24小时；通入饱和正戊烷/甲苯空气可选
Applications
Type testing and batch endurance sampling at gas valve plants; pre-certification self-test for AS/NZS / EN export valves; third-party lab valve life testing; incoming and supplier audits
About the manufacturer
Guangdong Endurance Electronic Equipment Co., Ltd provides non-standard customization, drawing confirmation, factory acceptance, on-site installation and commissioning, operation training and lifetime technical service; 12-month warranty and lifetime spare parts supply. Tel: 0760-88500902 / 13416787649. Web: en.zsnaili.com.